General Glasswasher Operation Instructions

The operating instructions provided below are generic operating instructions for that should apply to any commercial glasswasher. Therefore, it is important to note that none of these instructions is specific for your machine and you should always refer to the manufacturers' handbook provided at purchase for essential operations and maintenance.

Before Switching On The Machine Check:

  • Machine is empty
  • Wash tank(s) are clean
  • Filters/Strainers (and curtains if applicable) are in the position
  • Wash arms and jets are fully located
  • Rinse arms are in the position
  • The drain plug is in place
  • Detergent & Rinse Aid containers are full and without an airlock

Filling The Machine:

  • Check machine is ready for filling
  • Switch on at wall isolator
  • Close door(s)
  • Switch the machine on (filling will commence)
  • Wait for machine to reach operating temperature
  • The machine is now ready to wash.

Washing Procedure:

  • Always rack correctly
  • Select the correct wash cycle
  • Slide rack into the washer
  • Close door (if appropriate)
  • Allow washing to commence
  • Complete the full wash cycle without interruption
  • Allow dishes to dry before stacking
  • Always allow the machine to complete the whole washing process automatically
  • Never interrupt the wash program
  • Never forcibly increase the rack throughput

Washing Glasses:

  • Ensure that glasses are racked correctly
  • Use provided glass rack
  • Always place glasses facing down for best washing results
  • Ensure regular renovation of glasses

Pre-Rinsing:

  • Always pre-spray to remove excess soil
  • The machine is NOT a waste disposal unit
  • Not pre-rinsing will lead to poor wash results and might also lead to machine breakdown which would void any warranty on the machine.

Upon Completion Of Service:

  • Switch off the machine and isolate
  • Open doors and drain machine
  • Remove filters/strainer, (strainer baskets, curtains if applicable) and clean
  • Check wash jets and clear if necessary
  • Remove all food and debris from tank
  • Clean the wash tank
  • Replace all removable components
  • Leave the door ajar to allow the machine to dry

Chemical Checklist:

  • Always observe safety instructions
  • Never mix chemicals
  • Always ensure feed tubes are correctly placed in containers
  • Always ensure that there is sufficient chemical for the service period
  • Always observe COSHH regulations (printed on chemical containers)